Request a Quote for Lockers and Locker Supplies

Metal-Standard Style

The most popular and widely used locker in the industry. Ideal for most applications in school corridors and employee locker rooms. Doors and frames are made from heavy 16 gauge steel. Sides, tops, backs, bottoms and shelves are 24 gauge steel. Doors are available with or without louvers. Recessed or projecting handles are available.

Metal-Athletic Style

Ideal for applications that require a high degree of ventilation and strength, or where visual inspection of locker contents is desired. Doors are made from heavy 14 gauge steel. Sides, tops, bottoms and shelves are 16 gauge steel. Backs are 18 gauge steel. Doors and sides are perforated with a diamond shaped pattern allowing maximum air circulation while maintaining security.

Plastic-HDPE

Designed for cost effectiveness, low maintenance and durability, our solid plastic lockers are also aesthetically pleasing. Lockers come with a standard hasp for a padlock. Optional built in locks are available in combination, key and coin locks. (Single to Six Tier, Custom Sizes Available)

P-Lam/Wood Lockers

• 1/8" reveal
• 3⁄4" thick framing with select solid wood stiles and rails, 2 1/4" wide, typical
• PVC, Veneer or Laminate edges
• Solid Wood or Veneer Composite Center panels
• Square raised panel with radius edges, 50/50 split with center rail for doors over 42" long (louver and other styles available)
• Two coats of clear catalyzed lacquer on all surfaces, scuff sanded between coats
• Custom stain formulation

Tenant Lockers

Tenant and Industrial Storage Lockers from SpaceGuard Products provide instant, versatile, and safe storage for tenants, retail, and industry. Due to its heavy duty construction, our lockers are stronger and more durable than sheet metal lockers. The tightly woven 10-gauge wire mesh doesn't cause the potential injuries that sharp, exposed unprotected mesh or expanded metal lockers can.

Our wire mesh allows for full visibility and unrestricted circulation of air, light, and heat so it has minimal, if any, interference with fire suppressant systems in high-rise residential or office buildings.Our Wire Mesh Storage Lockers are also perfect for industrial and commercial applications to help reduce inventory shrinkage caused by employee theft. Wire mesh lockers provide security, yet visibility not offered by sheet metal products.

close

close

close

close

ZEE BASES: Used to raise lockers without legs 4" off the floor when there is no concrete or wood base. They provide a toe space in the front and a concealed flange for floor anchoring at the rear. (Not for use in welded lockers.)

CLOSED BASES: Provide 18 gauge closed metal front and end bases on knocked down lockers having legs. Front bases shall be installed between legs without overlap or exposed fasteners. Provide end bases on exposed ends. Bases shall be finished to match lockers.

OPENED BASE: At no additional cost 6" integral legs can be provided for an open base.

NO LEGS: Order lockers without legs when base is already provided by other.

close

FLAT TOPS

The default setup for lockers is the flat top configuration.

SLOPE TOPS

Slope tops are often used instead of flat tops to prevent the accumulation of dust and debris, and to discourage the use of locker tops as storage areas. There are three different types of slope top construction: Unit Slope Tops, Slope Hoods, and Slope Top Kits. Each is explained below.

Continuous Slope Top Hood

Continuous slope hoods fit on top of flat top lockers. They can be used on new lockers, or on a retrofit basis. All hoods are furnished in 72" lengths and must be cut to length during installation. Intermediate splices, ends and rear supports (2 per hood) complete the installation, and must be ordered separately.

close